This suppressor was designed exclusively for the Beeman 2027. It is 3d printed in black Polycarbonate. Check out the cross section below:
To install you must remove the muzzle cap on the end of the barrel before pressing this suppressor on by hand. It’s best to use a hammer and block of wood or another soft material pressed against the cap and barrel to remove the front sight post/muzzle cap. Check out our tactical conversion install video to see how that is done. Go to the 2:45 mark for the front sight removal.
It should be a press fit for most folks, but if it is loose or gets loose over time you may need to use silicone or threadlocker to keep it in place. If it affects accuracy, you can easily open up the internal diameter with a drill bit or round file until there is no clipping.