Description
This suppressor was designed exclusively for the AirForce TalonP. It replaces the shroud cap and does not require an adapter or any extra hardware to install. It is 3d printed in ABS plastic in the US by a veteran-owned business. The suppressor significantly reduces the airgun report without breaking the bank. It includes an o-ring groove like the stock shroud cap, but it doesn’t seem to make a difference installed or not.
To install:
- Loosen the top and bottom set screws that constrain the stock shroud cap
- Remove the shroud cap
- Insert the suppressor into the barrel shroud making sure to align the holes for the set screws
- Tighten the set screws sequentially, switching from top to bottom until tight
Please note: The buttstock pictured above is not for sale. Thank you
My only complaint, (and it's really too soon to tell for half of it) ,... is it is just a "hair" too small of diameter . **Suggestion , make it like the "Bandit" stock, where we need to sand the diameter down to "snugly" fit.
The other half is, make the nose of it a bit longer, maybe 1 1/2 or so.
Other than that...Very Good product.
Thanks again, looking forward to getting some other accessories like the grips for the TalonP and suppressors for some of my there guns.
Jim F.