THE LITTLE BUCK RAIL SCOPE MOUNT
DIRECTIONS FOR INSTALLATION
1.) Locate the stock screw at the top rear of the receiver and remove it using a phillips head screwdriver. (Set the screw aside, because you will need to use it for installation later)
2.) Now locate the front and rear of the buck rail. The rear is the side with the hole in it. Hold the rail at an angle and slide it over the rear sight. (Be sure that the nubs at the front bottom of the rail clear the rear sight as you slide the rail over it.)
3.) Rotate the rail down until it rests flat on the receiver.
4.) Insert the stock screw you removed earlier into the hole at the rear of the rail and screw it in until it is snug. (Be careful not to overtighten, so that you do not strip out the wood.)